Table Of Contents - Sony XR-C5100 Service Manual

Power amplifier section
Outputs Speaker outputs
(sure seal connectors)
Speaker impedance 4 - 8 ohms
Maximum power output 40 W × 4 (at 4 ohms)
General
Outputs Power antenna control
lead/Power amplifier
control lead/Telephone
ATT control lead (E model only)
Rear line out (1)
Tone controls Bass ± 8 dB at 100 Hz
Treble ± 8 dB at 10 kHz
Power requirements 12 V DC car battery
(negative ground)
Approx. 188 × 58 × 181 mm
Dimensions
× 2
(7 1 /
2
(w/h/d)
Approx. 182 × 53 × 164 mm
Mounting dimensions
× 2
(7 1 /
4
(w/h/d)
Mass Approx. 1.2 kg (2 lb. 10 oz.)
Supplied accessories Parts for installation and connections (1 set)
Front panel case (1)
Design and specifications are subject to change without notice.
× 7
3 / 1 / in.)
8 4
× 6
1 / 1 / in.)
8 2

TABLE OF CONTENTS

1. GENERAL
Location of Controls ....................................................... 3
Resetting the Unit ........................................................... 4
Detaching the Front Panel ............................................... 4
Setting the Clock ............................................................. 4
Installation ....................................................................... 5
Connection ...................................................................... 7
2. DISASSEMBLY
3. ASSEMBLY OF MECHANISM DECK
4. MECHANICAL ADJUSTMENTS
5. ELECTRICAL ADJUSTMENTS
Test Mode ........................................................................ 14
Tape Deck Section .......................................................... 14
Tuner Section .................................................................. 15
6. DIAGRAMS
6-1. IC Pin Function Description ........................................... 17
6-2. Printed Wiring Board -MAIN Section- ........................ 21
6-3. Schematic Diagram -MAIN Section- ........................... 23
6-4. Printed Wiring Board -PANEL Section- ...................... 27
6-5. Schematic Diagram -PANEL Section- ......................... 29
7. EXPLODED VIEWS
8. ELECTRICAL PARTS LIST
Flexible Circuit Board Repairing
• Keep the temperature of the soldering iron around 270 ˚C dur-
ing repairing.
• Do not touch the soldering iron on the same conductor of the
circuit board (within 3 times).
• Be careful not to apply force on the conductor when soldering
or unsoldering.
Notes on chip component replacement
• Never reuse a disconnected chip component.
• Notice that the minus side of a tantalum capacitor may be dam-
aged by heat.
- 2 -
......................................................... 9
............ 11
....................... 14
................................................ 33
............................... 36