Definitive Technology BP9000 SERIES Owner's Manual page 9

Connection Option 2: Speaker-Level + LFE
FIGURE 4 – Speaker-Level + LFE Connector Connection Diagram
For those who demand greater customization, Option 2 gives you the ability to control the amount of low
frequencies (those below the crossover point set in your receiver/processor) sent to the integrated subwoofer.
Should you prefer Option 2, we highly recommend setting the crossover point in your receiver/processor to 80Hz
or below to avoid disturbing the delicate blending between the subwoofer and midrange. In addition, careful
balance between the subwoofer output level of your receiver and the bass control on the back of your speaker
should be considered. We recommend starting with the bass control at 12 o'clock (as shown in Figure 4).
Directions:
• Connect speaker wire
from receiver/amplifier to
speaker level input on the
back of the speaker
• Connect RCA Cable from
Center Channel Pre-Out
on back of the receiver/
processor to LFE Input
on the back of the center
channel
• Adjust receiver or
processor settings
to: Speaker (Small);
Subwoofer (Yes)
9