Table of Contents
Advertisement
Installation
^ Slide the cover strip a into the
holders as shown.
^ Screw the fixing bracket d using the
hexagonal screw e to the pre-drilled
holes in the appliance door. Using
the pre-drilled holes in the appliance
door, secure a second pair of fixing
brackets d in the handle area of the
door.
66
^ Push the appliance two-thirds of the
way into its niche.
When doing this, make sure that the
mains cable does not get trapped.
Installation tip:
Tie a piece of string around the plug to
"lengthen" the mains cable.
Then grab the other end of the string
and pull the mains cable through the
housing unit to make it easier to
connect the appliance to the electricity
supply after installation.
With 16 mm thick unit walls:
^ Clip the spacers b and c on the
right-hand side of the hinges.
^ Open the appliance door.
Advertisement
Table of Contents
