Setup; Installing The Handle - Toro 22168 Operator's Manual

Setup

Loose Parts
Use the chart below to verify that all parts have been shipped.
Step
Handle
Bolt (5/16 x 1-1/4 inches)
Washer
Thin locknut (5/16 inch)
Bolt (5/16 x 1-1/2 inches)
1
Carriage bolt
Locknut (5/16 inch)
Bag support rod
Bag aligning plate
Cap locknut
Cable tie
2
Discharge tunnel plug
3
No parts required
Note: Determine the left and right sides of the
machine from the normal operating position.
Step
1

Installing the Handle

Parts needed for this step:
1
Handle
2 Bolt (5/16 x 1-1/4 inches)
4
Washer
2 Thin locknut (5/16 inch)
2
Bolt (5/16 x 1-1/2 inches)
1 Carriage bolt
2
Locknut (5/16 inch)
1 Bag support rod
1 Bag aligning plate
3 Cap locknut
3 Cable tie
Procedure
1. Mount the handle to the outside of the mower
housing (using the bottom hole) with two
Description
1. Bag support rod
2. Carriage bolt
3. Bag aligning plate
4. Cap locknuts (3)
5. Handle
6. Bolt, (5/16 x 1-1/4 inches)
7. Handle latch (2)
2. Secure the handle latches to the handle with
8
Qty.
1
2
4
2
2
1 Install the handle.
2
1
1
3
3
1 Install the discharge tunnel plug.
–
Fill the crankcase with oil.
bolts (5/16 x 1-1/4 inches), washers, and thin
locknuts (5/16 inch) (Figure 3).
Figure 3
8. Thin locknut (2)
9. Bottom hole in housing
10. Washer (4)
11. Locknut (2)
12. Bolt, (5/16 x 1-1/2 inches)
13. Cable tie (3)
(2)
2 bolts (5/16 x 1-1/2 inches), washers, and
locknuts (5/16 inch) (Figure 3).
Use
(2)