Every 500 Hours - Toro groundsmaster 3240-d Operator's Manual

1.51

EVERY 500 HOURS

Perform routine checks : refer
Thoroughly clean the machine:
IMPORTANT: PREVENT DAMAGE - Keep water away from electrical components. Use a dry
cloth or brush to clean such areas.
Service the hydraulic system : This procedure is best carried out when the hydraulic oil is warm (not
hot). Lower the cutterdecks to the ground and drain the hydraulic system by removing the hydraulic tank
drain plug. Remove the oil tank filler flange to gain access to the suction strainer. Unscrew and remove
the strainer and clean with paraffin or petrol before replacing. Renew the strainer if there are any signs
of damage.
Remove the oil filler cap strainer and clean before replacing. Renew the strainer if there are any signs
of damage.
Renew the return line oil filter element, refer - RUNNING IN PERIOD AT FIRST 50 HOURS.
Renew the transmission oil filter element, refer - RUNNING IN PERIOD AT FIRST 50 HOURS.
Replace the drain plug and refill the hydraulic tank with fresh clean hydraulic oil of the recommended
grade, refer - SPECIFICATIONS.
Run the machine and operate all hydraulic systems until the hydraulic oil is warm. Recheck the oil level
and top up as necessary to the upper mark on the sight level gauge.
MAINTENANCE
- DAILY BEFORE USE.
- EVERY 50 HOURS.
- EVERY 250 HOURS.
2
3
1
4
1. Drain plug
2. Oil tank filler flange
4P994C06A
3. Suction strainer
4. Filler strainer
1.51