Table of Contents
Advertisement
Product Specifications
Percussion drill
Order number
Speed control
Right/Left rotation
Rated input power
Power output
Impact rate
Impact energy per
stroke
Nominal speed
Tool holder SDS-plus
Spindle collar diameter
Maximum drill diameter:
Concrete
Wood
Steel
Weight without mains
cable approx.
Protection class
Please observe the order number of your machine.
The trade names of the individual machines may vary.
Noise/Vibration Information
Measured values determined according to EN 50 144.
The A-weighted noise levels of the tool are typically:
Sound pressure level: 88 dB(A)
Sound power level: 101 dB(A)
Wear ear protection!
The typically weighted acceleration is 11 m/s
Intended Use
The machine is intended for hammer drilling in con-
crete, brick and stone. It is likewise suitable for drilling
without impact in wood, metal, ceramic and plastic.
Machines with electronic control and right/left rotation
are also suitable for screw driving and thread cutting.
1 619 929 622 • (03.04) T
GBH 2 POWER
PLUS
0 611 234 7..
q
q
[W] 500
[W] 300
[per min] 0 ... 3900
[J] 1.5
[RPM] 0 ... 850
q
[mm] 43
(Euro-Standard)
[mm]
20
[mm]
30
[mm]
13
[kg] 2.45
/ II
2
.
Product Elements
The numbering of the product elements refers to the
illustration on the fold-out page.
1 Tool holder (SDS-plus)
2 Dust protection cap
3 Locking sleeve
4 Locking button
5 On/off switch
6 Right/Left rotation switch
7 Operational mode selection switch
8 Button on the auxiliary handle
9 Auxiliary handle
10 Depth stop
11 Drill chuck*
12 Drill chuck adapter shaft*
13 SDS-plus adapter*
* Not all the accessories illustrated or described are in-
cluded in standard delivery.
If the cable is damaged or cut through while work-
s
ing, do not touch the cable but immediately pull the
mains plug. Never use the machine with a dam-
aged cable.
Connect machines that are used in the open via a
s
residual current device (RCD) with an actuating
current of 30 mA maximum. Do not operate the
machine in rain or moisture.
Always direct the cable to the rear away from the
s
machine.
English–1
For Your Safety
Working safely with this machine is
possible only when the operating
and safety information are read
completely and the instructions
contained therein are strictly fol-
lowed.
In addition, the general safety
notes in the enclosed booklet must
be observed.
Before using for the first time, ask
for a practical demonstration.
Wear ear protection to prevent damage
to your hearing.
Wear safety glasses.
For long hair, wear hair protection.
Work only with close-fitting clothes.
Advertisement
Table of Contents
