Setup - Toro 30722 Operator's Manual

Setup

Loose Parts
Use the chart below to verify that all parts have been shipped.
Procedure
1
2
3
4
5
6
7
8
9
10
Media and Additional Parts
Description
Parts Catalog
Operator's Manual
Declaration of Conformity
Description
Large castor wheel assembly
Small castor wheel assembly
No parts required
No parts required
Drive shaft
No parts required
No parts required
Bolt, 5/16 x 1-3/4 inches
Locknut, 5/16 inches
Roll pin, 3/16 x 1-1/2 inches
No parts required
No parts required
No parts required
Qty.
2
2
–
–
1
–
–
2
2
2
–
–
–
Qty.
1
Review the material and save in an appropriate place:
1
1
7
Use
Install the castor wheel assemblies.
Lower the grass deflector
Install the ball joints and connect the lift
cylinder
Install the drive shaft to the traction unit
Connect the right-hand push arm to the
cutting unit
Connect the left-hand push arm to the
cutting unit
Connect the drive shaft to the cutting
unit gear box
Install the lift chains
Grease the machine.
Install rear weight
Use