Advertisement
Snooze may be repeated up to 7 times.
•
In snooze mode, press any button except SNOOZE/LIGHT to
•
stop alarm for one day.
Note: The alarm is crescendo sound. The alarm will sound for 2
minutes and then shut off completely if no buttons are pressed.
Press the SNOOZE/LIGHT button to
activate the backlight for 15 seconds.
Hold the ▼ button to start or stop a WWVB signal search.
•
WWVB Icon will flash when searching.
•
For information about WWVB visit:
www.nist.gov/pml/div688/grp40/wwvb.cfm
Tip: When batteries are inserted, the alarm clock will start
searching. If there is no WWVB reception, the alarm clock will
search the WWVB time signal every hour until the WWVB time
is received. After reception, this alarm clock will automatically
search for the atomic signal daily at 2:00am.
If the display of the alarm clock is distorted or the alarm
•
clock is not functioning properly, check that batteries are
fresh and press the RESET button one time.
The alarm clock will fully populate then return to default
•
settings.
Position the alarm clock six feet from other electronics for
•
best WWVB reception.
Have the front or back of the alarm clock facing Colorado.
•
•
Do not mix old and new batteries
•
Do not mix Alkaline, Standard, Lithium, or Rechargeable Batteries
•
Always purchase the correct size and grade of battery suitable for
the intended use.
•
Replace all batteries of a set at the same time.
617-1392B/617-1392W www.lacrossetechnology.com/support
Backlight
Atomic Time Signal Search
Reset Button
Position Alarm Clock
Care and Maintenance
SNOOZE/LIGHT
Page | 4
Advertisement
