Luxon Video TVR series Quick Start Manual

Hide thumbs Also See for TVR series:

Advertisement

Quick Links

Digital Video Recorder

Quick Operation Guide

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the TVR series and is the answer not in the manual?

Questions and answers

Subscribe to Our Youtube Channel

Summary of Contents for Luxon Video TVR series

  • Page 1: Digital Video Recorder

    Digital Video Recorder Quick Operation Guide...
  • Page 2: Table Of Contents

    Quick Operation Guide of Digital Video Recorder TABLE OF CONTENTS DVR Pre-Installation ............................5 DVR Installation .............................. 5 Hard Disk Installation ............................. 5 Front Panels ..............................7 Rear Panels ..............................11 Peripheral Connections ..........................13 Wiring of Alarm Input ........................... 13 Wiring of Alarm Output ........................
  • Page 3 Quick Operation Guide of Digital Video Recorder Regulatory information FCC information This equipment has been tested and found to comply with the limits for a digital device, pursuant compliance: to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference when the equipment is operated in a commercial environment.
  • Page 4: Trademarks And Registered Trademarks

    Quick Operation Guide of Digital Video Recorder Trademarks and Registered Trademarks  Windows and Windows mark are trademarks or registered trademarks of Microsoft Corporation in the United States and/or other countries.  HDMI, HDMI mark and High-Definition Multimedia Interface are trademarks or registered trademarks of HDMI Licensing LLC.
  • Page 5 Quick Operation Guide of Digital Video Recorder Thank you for purchasing our product. If there is any question or request, please do not hesitate to contact dealer. This manual is applicable to 4/8/16/32ch HD-TVI DVR.
  • Page 6: Dvr Pre-Installation

    Quick Operation Guide of Digital Video Recorder DVR Pre-Installation The HD-TVI series DVR is highly advanced surveillance equipment that should be installed carefully. Please take into consideration the following precautionary steps before installation of the DVR. 1. Keep all liquids away from the DVR. 2.
  • Page 7 Quick Operation Guide of Digital Video Recorder 3. Connect the power cable to the HDD. 4. Place the HDD on the bottom of the device and then fasten the screws on the bottom to fix the HDD. 5. Re-install the cover of the DVR and fasten screws.
  • Page 8: Front Panels

    Quick Operation Guide of Digital Video Recorder Front Panels Front Panel of 4ch/8ch series Front Panel of 16ch series Description of Front Panel Name Function Description POWER: the POWER indicator turns green when NVR is powered up. READY: The indicator light is green when the device is running normally.
  • Page 9 Quick Operation Guide of Digital Video Recorder Name Function Description Enter numeral “5”; Enter letters “JKL”; 5/JKL/EDIT: Delete characters before cursor; Check the checkbox and select the ON/OFF switch; Start/stop record clipping in playback. Enter numeral “6”; 6/MNO/PLAY: Enter letters “MNO”; Playback, for direct access to playback interface.
  • Page 10 Quick Operation Guide of Digital Video Recorder Front Panel of 32ch series Name Function Description POWER ON/OFF Power on/off switch. USB Interface Connect to USB mouse or USB flash memory. IR Receiver Receiver for IR remote control devices. POWER Power indicator lights in green when DVR is powered up. READY Ready indicator is normally green, indicating that the DVR is functioning properly.
  • Page 11 Quick Operation Guide of Digital Video Recorder camera; The F2 button can be used to cycle through tab pages. Enter numeral “4”; Enter letters “GHI”; 4GHI/ESC Exit and back to the previous menu. Enter numeral “5”; Enter letters “JKL”; 5JKL/EDIT Delete characters before cursor;...
  • Page 12: Rear Panels

    Quick Operation Guide of Digital Video Recorder Rear Panels The rear panel vaires according to different models. 4/8Ch Series without alarm 4/8Ch Series with alarm 16CH Series without alarm 16CH Series with alarm...
  • Page 13 Quick Operation Guide of Digital Video Recorder Item Description VIDEO IN BNC interface for TVI and analog video input. AUDIO IN RCA connector AUDIO OUT RCA connector DB15 connector for VGA output. Display local video output and menu. HDMI HDMI video output connector. USB Port Universal Serial Bus (USB) port for additional devices.
  • Page 14: Peripheral Connections

    Quick Operation Guide of Digital Video Recorder Peripheral Connections Wiring of Alarm Input The alarm input is an open/closed relay. To connect the alarm input to the device, use the following diagram. If the alarm input is not an open/close relay, please connect an external relay between the alarm input and the device.
  • Page 15: Rs-485 And Controller Connection

    Quick Operation Guide of Digital Video Recorder Ensure signal cables are in tight. 3. Connect pluggable block back into terminal block. RS-485 and Controller Connection Series 1 To connect PTZ to the DVR: 1. Disconnect pluggable block from the RS-485 terminal block. 2.
  • Page 16: Termination Switch Operation

    Quick Operation Guide of Digital Video Recorder part. Ensure signal cables are in tight. 3. Connect Ta on controller to D+ on terminal block and Tb on controller to D- on terminal block. Fasten stop screws. 4. Connect pluggable block back into terminal block. Make sure both the controller and DVR are grounded.
  • Page 17: Specifications

    Quick Operation Guide of Digital Video Recorder Specifications Table 1 Specification Model 16CH Video compression H.264 4-ch 8-ch 16-ch Analog and HD-TVI BNC interface (1.0Vp-p, 75 Ω) video input Supported camera types 720P/25, 720P/30, 720P/50, 720P/60, 1080P/25, 1080P/30, CVBS Video/Audio 1-ch 2-ch 2-ch...
  • Page 18: Table 2 Specification

    Quick Operation Guide of Digital Video Recorder Table 2 Specification Model 4CH(with Alarm) 8CH(with Alarm) 16CH(with Alarm) Video compression H.264 4-ch 8-ch 16-ch Analog and HD-TVI BNC interface (1.0Vp-p, 75 Ω) video input Supported camera types 720P/25, 720P/30, 720P/50, 720P/60, 1080P/25, 1080P/30, CVBS Video/Audio 1-ch 2-ch...
  • Page 19: Table 3 Specification

    Quick Operation Guide of Digital Video Recorder Table 3 Specification Model 32ch Video compression H.264 32-ch Analog and HD-TVI BNC interface (1.0Vp-p, 75 Ω) video input Supported camera 720P/25, 720P/30, 720P/50, 720P/60, 1080P/25, 1080P/30, CVBS types Video/ 8-ch (up to 32-ch) Audio input IP video input Up to 2MP resolution...
  • Page 20: Hdd Storage Calculation Chart

    Quick Operation Guide of Digital Video Recorder HDD Storage Calculation Chart The following chart shows an estimation of storage space used based on recording at one channel for an hour at a fixed bit rate. Bit Rate Storage Used 128K 160K 192K 224K...
  • Page 21: Accessing By Web Browser

    Quick Operation Guide of Digital Video Recorder Accessing by Web Browser Logging In You can get access to the device via web browser. Open web browser, input the IP address of the device and then press Enter. The login interface appears. Input the user name and password, and click the Login button.
  • Page 22: Recording

    Quick Operation Guide of Digital Video Recorder Interface Introduction Name Description Displays the list of channels and the playing and recording status of each Channel List channel. Live View Window Displays the image of channel, and multi-window division is supported. Play Control Bar Play control operations are supported.
  • Page 23: Playback

    Quick Operation Guide of Digital Video Recorder 4. Click Edit to edit record schedule. 5. Choose the day in a week to configure scheduled recording. 1) Configure All Day or Customize Record:  If you want to configure the all-day recording, please check the All Day checkbox. ...
  • Page 24 Quick Operation Guide of Digital Video Recorder Start Playback Steps: 1. Click Playback on the menu bar to enter playback interface. 2. Click the camera from the device list for playback. 3. Select the date from the calendar and click Search. 4.
  • Page 25: Menu Operation

    Quick Operation Guide of Digital Video Recorder Menu Operation Menu Structure Menu Playback Maintenance Export Manual Record Camera Shutdown Configuration Normal Record General Schedule General System Info Logout Event Alarm Advanced Encoding Image Alarm Shutdown Information Advanced Reboot Manual VQD RS-232 Import/Export Network...
  • Page 26: Live View

    Quick Operation Guide of Digital Video Recorder 4. Turn off the power switch on the rear panel when the note appears. After the device starting up, the wizard will guide you through the basic settings, including edting password, date and time settings, network settings, HDD initializing, and recording. Live View Some icons are provided on screen in Live View mode to indicate different camera status.
  • Page 27 Quick Operation Guide of Digital Video Recorder The online cameras with same network segment will be displayed in the camera list. Click the button to add the camera. The added camera is marked in white while the camera not added is marked in yellow. Explanation of the icons Icon Explanation...
  • Page 28: Record

    Quick Operation Guide of Digital Video Recorder added. Click Add to add the camera. (For the encoders with multiple channels only) check the checkbox of Channel No. in the pop-up window, as shown in the following figure, and click OK to finish adding. Record Before you start: Make sure that the HDD has already been installed.
  • Page 29: Backup

    Quick Operation Guide of Digital Video Recorder  OPTION 2: 1. Enter the Playback menu. Right click a channel in live view mode and select Playback from the menu. Pressing numerical buttons on the front panel will switch playback to related channels during playback process. 2.
  • Page 30 Quick Operation Guide of Digital Video Recorder 2. Enter Export interface, choose backup device and click the Export button to start exporting. 3. Check backup result. Choose the record file in Export interface and click button to check it.

Table of Contents