Remove The Machine From Storage - Toro 20372 Operator's Manual

1. Remove the ignition key (electric-start model only).
2. Loosen the handle knobs until you can move the upper
handle freely.
3. Fold the upper handle forward as shown in
Important: Route the cables to the outside of the
handle knobs as you fold the handle.
4. To unfold the handle, reverse the steps above.
Remove the Machine from
Storage
1. Check and tighten all fasteners.
2. Remove the spark plug and spin the engine rapidly
by pulling the recoil-start handle or using the electric
starter (electric-start model only) to blow the excess
oil from the cylinder.
3. Install the spark plug and tighten it with a torque
wrench to 20 N-m (15 ft-lb).
4. Perform any maintenance procedures; refer to
Maintenance (page
5. Check the engine-oil level; refer to
Engine-Oil Level (page
6. Fill the fuel tank with fresh gasoline; refer to
Fuel Tank (page 8).
7. Connect the wire to the spark plug.
8. Charge the battery for 24 hours (electric-start model
only); refer to 4 Charging the Battery (page
Figure
G017313
Figure 32
15).
Checking the
9).
6).
32.
Filling the
21