Table of Contents
Advertisement
8.
Repeat steps 4–7 until the slope of the blade is
approximately 1/4" (7 mm) lower in the front
than it is in the rear.
Removing the Mower
The mower is most easily removed from the tractor
when done on a level concrete surface. Rougher dirt
or lawn surfaces make removing the mower more
difficult.
1.
Apply the parking brake, start the tractor, and
raise the attachment lift.
2.
Get off the tractor.
3.
Lower the rear center wheel. Do this by:
A. Placing the height–of–cut lever on the deck
to the position for lowest cut.
B. Removing the hairpin cotter from the wheel
rod.
C. Pulling the rod toward the outside of the
mower, inserting the end of the rod into the
hole in the height–of–cut plate, then
installing the hairpin cotter into the second
hole of the wheel rod as shown (Fig. 23).
4
2
1
Figure 23
1. Cotter pin
2. Wheel rod
4.
Set the height of the (2) front mower wheels and
turn the wheels parallel to the mower by
removing the clevis pins and hairpin cotters,
then turning and raising or lowering the wheels
until you can put the clevis pins and hairpin
cotters in the third position from the top (Fig. 3).
5.
Lower the deck until its weight is completely on
its wheels, not on the tractor.
6.
Turn the ignition key to "STOP" to stop the
engine. Remove the ignition key.
7.
Remove the grille.
Installation
3
m–3579
3. Hole in height–of–cut plate
4. Rear center wheel
13
Advertisement
Table of Contents
