Toro 30834 Operator's Manual page 8

Choosing Accessories
Grass Cutting: 0.75 to
1.75 inch (1.9 to 4.4 cm)
Height-of-Cut
Grass Cutting: 2.00 to
2.50 inch (5 to 6.4 cm)
Height-of-Cut
Grass Cutting: 2.75 to
4.00 inch (7 to 10 cm)
Height-of-Cut
Leaf Mulching
Pros
Cons
Optional Equipment Configuration
Angle Sail Blade High Lift Parallel
Sail Blade
Do not use with the
mulching baffle
Recommended in most May work well in light or
applications sparse turf
Recommended for thick Recommended for light
or lush turf or sparse turf
May work well in lush turf Recommended in most
applications
Recommended for use Not Allowed
with the mulching baffle
Even discharge at
More lift and higher
lower height of cut discharge velocity
Cleaner look around Sparse or limp turf
bunkers and fairways is picked up at
Lower power high height of cut
requirements Wet or sticky clippings
are discharged efficiently
Requires more power to
Does not lift the grass
well in high height run in some applications
of cut applications Tends to windrow at lower
Wet or sticky grass height of cut in lush grass
has a tendency to build Do not use with the
up in the chamber, mulching baffle
leading to poor quality
of cut and higher power
requirement
Mulching Baffle
Has been shown to
improve dispersion and
after cut performance
on northern grasses that
are cut at least three
times per week and less
than 1/3 of the grass
blade is removed.
Do not use with the
high lift parallel sail
blade
Use with combination sail
or angle sail blade only
May improve dispersion
and appearance in
certain grass cutting
applications Very good
for leaf mulching
Grass will build up in the
chamber if attempting to
remove too much grass
with baffle in place
8
Roller Scraper
Can be used any time
that rollers build up
with grass or large flat
grass clumps of grass
are seen. The scrapers
may actually increase
clumping in certain
applications.
Reduces roller buildup in
certain applications