Toro 78370 Operator's Manual page 14

Installation
8. Make sure the parking brake is set and turn the
ignition key to "STOP" to stop the engine.
Remove the key.
9. Press the button of the mid Attach–A–Matic
and twist the lever counterclockwise to release
the mower (Fig. 20).
1
Figure 20
1. Mid Attach–A–Matic
button
10. Pull the two spring–loaded J–pins from the deck
lift arms and twist them slightly so that they stay
disengaged (Fig. 21).
1
Figure 21
1. J–pin
11. If you wish to remove the pulley box, push the
latch release buttons on the front
Attach–A–Matic (Fig. 22) and raise the latch
levers to open the latches holding the pulley box.
Remove the pulley box.
12
2
m–3457
2. Mid Attach–A–Matic
lever
m–3456
1
Figure 22
1. Front Attach–A–Matic
button (one on each side)
2. Front Attach–A–Matic
latches
12. Start the tractor and raise the attachment lift to
provide ample clearance to slide out the mower.
Then turn the ignition key to "STOP" to stop the
engine. Remove the key.
13. Slide the mower out from the driver's right–hand
side of the tractor.
2
2
3
m–3458
3. Pulley box