Installation; Loose Parts; Mower Preparation - Toro 78363 Operator's Manual

Installation

Loose Parts

Note: Use the chart below to identify parts used for assembly.
DESCRIPTION
Discharge chute
Nylon washer 3/8"
Spring
Rubber bushing
Flat washer 1/2"
Lock nut 3/8"
Cotter pin 3/4"
PTO drive belt
Pulley box
Operator's Manual

Mower Preparation

Install the Discharge Chute
1. Locate the items shown (Fig. 1).
2. Place the short end of the spring into the small
hole in the discharge chute.
3. Position the spring and discharge chute over the
post on the rear of the deck and secure them with
a 1/2" (13 mm) washer and a 3/4" (19 mm)
cotter pin (Fig. 1).
4. Make sure the loop in the spring slides over the
stud on the mower housing.
5. Slide the rubber bushing and nylon washer over
the stud at the front of the mower.
6. Place the discharge chute over the stud and
secure it with a second nylon washer and 3/8"
lock nut (Fig. 1). The lock nut must be
tightened flush with the end of the stud.
QTY.
1
2
1
1 Install discharge chute
1
1
1
1 Install PTO drive belt
1 Install pulley box
1 Read before operating
IMPORTANT: The discharge chute must be
spring loaded in the down position. Lift the
chute up to test that it snaps to the full down
position.
1
7
6
1. Discharge chute
2. Spring
3. Cotter pin 3/4" (19 mm)
4. Washer 1/2" (13 mm)
5. Rubber bushing
USE
4
2
9
5
Figure 1
6. Plastic washer
7. Jam nut 3/8"
8. Loop in spring
9. Post on mower housing
10. Stud on mower housing
3
8
10
3