Assembly; Handle; Gas Tank - Toro 22162 Operator's Manual

Assembly

Handle

1. Mount handle to outside of mower housing, using
bottom hole, with (2) 5/16–18 x 1–1/4" lg. capscrews,
washers, and thin nylon insert locknuts (Fig. 2).
2. Secure handle latches to handle with (2) 5/16–18 x
1–1/2" lg. capscrews, washers and nylon insert
locknuts (Fig. 2).
Note: Handle height is adjustable for operator comfort.
Stand behind mower handle to gauge height. To adjust
handle height, reposition capscrews and locknuts securing
handle latches to handle into other mounting holes in
latches.
3. Slide bag support rod thru top mounting holes in
handle and secure each end with a cap locknut (Fig. 2).
1
Figure 2
1. Handle latch
2. Bag support rod
2
3
4
534
3. Cap locknut
4. Handle
4. Use a cable tie to secure the control cables to left
handle below the bag support rod.
5. Pull starter rope through rope guide on handle (Fig. 3).
2
1. Rope guide

Gas Tank

1. Start self-tapping screws into bottom of gas tank and
then remove screws.
2. Hook plastic clips on front of gas tank into slots on
rear of engine (Fig. 4).
3. Secure gas tank to tank base with (2) self-tapping
screws (Fig. 4). Do not overtighten screws.
5
1
Figure 3
2. Starter rope
m–210