Advertisement
Installation Instructions
Assembly And Installation
NOTE:
The following installation instructions assume that
Projecta's rear projector cart (part number 11630010)
has already been completely assembled. Do NOT
attempt to install this monitor arm to any other cart or
stand.
1.
Use four #10-24 x 7/16" Phillips screws with captured
washers (E) and two guard clamps (C) to secure guard
bracket (B) to guard base (A). (See Figure 1)
1
(C) x 2
Figure 1
2.
Loosely install remaining four #10-24 x 7/16" Phillips screws
with captured washers (E) through guard base (B) holes
and into four slide nuts (D). (See Figure 2)
(E) x 4
2
Figure 2
(E) x 4
(A)
(B)
(B)
(D) x 4
3.
Remove end cover from rear projector arm. (See Figure 3)
Figure 3
4.
Slide assembled protection guard onto projector arm by
inserting slide nuts (D) into corresponding grooves on arm.
(See Figure 4)
5.
Tighten screws when protection guard is in desired position.
(See Figure 4)
6.
Reinstall end cover to projector arm. (See Figure 4)
4
(E) x 4
5
Figure 4
11830027
3
4
6
5
Advertisement
