Page 1
I N S T A L L A T I O N I N S T R U C T I O N S Instrucciones de instalación Istruzioni di installazione Installationsanleitung Installatie-instructies Instruções de Instalação Instructions d´installation Interactive Dry Erase Rear Projector Protection Guard Spanish Product Description German Product Description Portuguese Product Description Italian Product Description Dutch Product Description French Product Description 11830027...
Milestone assumes no responsibility for accuracy, completeness or sufficiency of the information contained in this document. Projecta® is a registered trademark of Milestone AV Technologies. All rights reserved. IMPORTANT SAFETY INSTRUCTIONS WARNING: A WARNING alerts you to the possibility of serious injury or death if you do not follow the instructions.
Installation Instructions 11830027 DIMENSIONS 444.5 17.50 108.8 4.28 LATERAL SHIFT TOOLS REQUIRED FOR INSTALLATION PARTS A (1) [guard base] B (1) [guard bracket] D (4) E (8) C (2) [slide nut] #10-24 x 7/16” [guard clamp]...
Remove end cover from rear projector arm. (See Figure 3) NOTE: The following installation instructions assume that Projecta’s rear projector cart (part number 11630010) has already been completely assembled. Do NOT attempt to install this monitor arm to any other cart or stand.
Page 6
11830027 Installation Instructions Adjustments Lateral Shift Loosen four screws holding guard bracket (B) to guard base (A). (See Figure 5) Adjust guard bracket lateral position as desired. (See Figure Tighten four screws holding guard bracket (B) to guard base when desired position is achieved. (See Figure 5)