Table of Contents
Advertisement
CHECK VAPORIZER PLACEMENT
Place the Vaporizer in a stable position on a firm, flat surface at least four feet away
from bedside and out of reach of children.
·
Protect floor, rug or furniture by placing the vaporizer on a non-metallic, water
proof, heat-resistant surface.
·
DO NOT direct steam flow directly at user, walls, or furniture.
·
DO NOT place the vaporizer on or near wood, or furniture that can be damaged
by too much moisture.
·
KEEP OUT OF REACH OF CHILDREN. Steam can cause burns.
CAUTION
DO NOT operate the vaporizer without water in the Water Tank.
DO NOT plug or unplug the Power Cord with wet hands as electric
shock could occur.
1. UNRAVLE CORD BEFORE USE. Failure to do so could cause overheating and
possible fire hazard.
NOTE: Always unplug cord from electrical outlet before removing steam unit and
when vaporizer is not in use. Always allow vaporizer to cool completely before
moving, cleaning, or storing.
2. FILL WATER TANK. Remove steam unit. Fill
water tank with tap water to water fill line on
water tank.
CAUTION: Do not overfill.
3. ADD SALT. Add approximately 1/8 teaspoon of
salt to the water and mix thoroughly. It is
imperative to mix thoroughly. The salt has no
effect on the purity of the steam or medication.
BEFORE EACH USE
OPERATION AND USE
CAUTION: Too much salt can cause
excessive boiling or blown fuse.
4. REPLACE STEAM UNIT. Hold down
5
steam unit for ten seconds to allow
water to enter the housing and seat it
properly in the water tank. If steam
unit floats, container is overfilled.
Advertisement
Table of Contents
