Troubleshooting - TRENDnet TEW-435BRM Quick Installation Manual

Hide thumbs Also See for TEW-435BRM:

Troubleshooting

Q1:

I typed http://192.168.0.1 in my Internet Browser's Address Bar, but an error

message says "The page cannot be displayed." How can I get into the

TEW-435BRM's web configuration page?

A1:

First, check your hardware settings again by following the instructions in

Section 2. Second, make sure the LAN and WLAN lights are lit. Third, make sure

your TCP/IP settings are set to Obtain an IP address automatically (see the

steps below).

1. Go into the Control Panel and double-

click the Network Connections icon,

right-click the Local Area Connection

icon and then click Properties.

2. Click Internet Protocol (TCP/IP) and

then click Properties. Then click on

Obtain an IP address automatically.

Fourth, press on the factory reset button for 15 seconds.

Q2:

The Modem does not auto-detect my DSL connection. What should I do?

A2:

First, verify that your DSL account is activated. Second, make sure all the

cables are properly connected (see Section 2). Third, in Section 3, select manual

selection in the Setup Wizard and configure the Modem based on information

provided by your ISP.