Advertisement
WARNING: Unplug cord from electrical
outlet before servicing.
STEP 1: Remove Power Nozzle Assembly
Lay cleaner on flat surface with bottom side of nozzle
(brush side) facing you then:
A) Remove swivel clamp screws and clamp.
B) Remove the two screws at the outer rear corners of the
nozzle base plate only.
CLAMP SCREWS
STEP 2: Remove Belt
Gently rock rear wheels and base plate up and out of
nozzle. Lift brush roll from holder. Remove old belt and
debris. (Dirt and debris may have been the cause of a
broken belt.)
STEP 3: Install New Belt
Place new belt over end of motor shaft and brush roll.
Be Sure Belt Is Not Twisted.
Place brush roll back into its holder. Be sure flat side of
metal brush roll ends are up.
T
R
o
eplace
STEP 4: Replace Power Nozzle Assembly
Line up tabs in front of base plate with slots in nozzle
cover. Press down on front while rocking base back into
place. Be sure front tabs are in lock position. Replace
screws at rear corners. Reattach swivel clamp to nozzle
base.
SCREWS
To order:
Replacement Belts
Call your authorized ORECK Service Centerr, your
authorized ORECK dealer, or the ORECK Service Center
Hotline toll free at:
6
Belt
US: 1-800-989-3535
CANADA: 1-888-676-7325
Part No. OR114
Advertisement
