Advertisement
Assembly
To assist you in identifying components of your Travel Iron/Steamer,
the parts have been numbered as follows:
1. Steam Burst Button
2. Cord Protector/Power Cord
3. Water Tank Release Button
4. Water Tank Lid
5. Detachable Handle Cover/Water Tank
6. Handle Base
7. Temperature Indication Point
8. LED Light
9. Temperature Control Knob
10. Voltage Selector
11. Housing
12. Handle Release Button
13. Base Plate
14. Soleplate
15. Detachable Lint Remover
16. Detachable Clothes Brush
17. Measuring Cup
General Information
Before Initial Use
1. Before each use, always remove the detachable lint remover and verify the voltage
rating on the appliance corresponds to the voltage in your home or hotel. Replace the
Lint Remover.
2. Some parts of the appliance have been slightly greased and as a result the unit may
smoke slightly when switched on for the first time. After a short while, however, this
will cease.
3. Normal tap water can be used, but if you live in a hard water area, using distilled
water is recommended to insure optimum performance of the unit.
Voltage Selection
This appliance is provided with a voltage selector. It can
be used on 120VAC or 230VAC main power. This appliance
will be set to the 120VAC setting at the factory. Before
operating this appliance, be sure the dual voltage selector
corresponds to the voltage in your home or hotel. To
change the
voltage, turn the dual voltage selector locat-
ed under the detachable lint remover with a coin (Fig. A).
2
1
17
3
(Fig. A)
3
4
5
6
7
8
9
10
11
12
13
14
15
16
Advertisement
