Related Manuals for Philips DS1600/12
Summary of Contents for Philips DS1600/12
- Page 1 Always there to help you Register your product and get support at www.philips.com/support DS1600/12 Question? Contact Philips User manual...
-
Page 3: Table Of Contents
Contents 1 Important Safety Notice 2 Your Docking Speaker Introduction What's in the box Overview of the main unit 3 Get started Connect power Turn on 4 Play Play audio from iPod/ iPhone/ iPad Play through an audio cable Other features Update the firmware 5 Product information Specifications... -
Page 4: Important
1 Important Your product is designed and manufactured with high quality materials and components, which can be recycled and reused. Safety Only use attachments/accessories specified by the manufacturer. When this crossed-out wheeled bin symbol is Use only power supplies listed in the user attached to a product it means that the product manual. -
Page 5: Your Docking Speaker
Congratulations on your purchase, and iPod, iPhone, or iPad, respectively, and has welcome to Philips! To fully benefit from the been certified by the developer to meet support that Philips offers, register your product Apple performance standards. -
Page 6: Overview Of The Main Unit
h Display panel Overview of the main unit • Adjust volume. j Toggle switch for lightning/30-pin control • Adjust brightness of display and bottom light. a 30-pin connector b Lightning connector c TIME/DATE • Display time and date. • Set time and date format. •... -
Page 7: Get Started
3 Get started Switch to standby mode DS1600 switches to standby mode in the following situations: Always follow the instructions in this chapter in • In dock mode: no audio signal from the sequence. docked iPod/iPhone/iPad over 15 minutes. In AUDIO IN mode: no audio signal •... -
Page 8: Play
4 Play Switch the dock Switch the dock between the lightning connector and 30-pin connector for different generation of Apple device. Slide the switch to the right. Play audio from iPod/ iPhone/ » The dock swivels and the alternate iPad connector is accessible. -
Page 9: Play Through An Audio Cable
When using DS1600 for the first time, a Listen to the iPod/ iPhone/ iPad required software application automatically pops up. Note • Make sure that the iPod/ iPhone/ iPad is loaded correctly. • Start music play in your iPod/ iPhone/ iPad. »... -
Page 10: Other Features
B: If no iPod/iPhone/iPad is docked, you can set Charge your mobile phone time manually. Charge your mobile phone through the USB In standby mode, press TIME/DATE to socket in DS1600 with a USB cable (not display [--:--]. supplied). Press and hold TIME/DATE for 2 seconds to activate time setting. -
Page 11: Update The Firmware
Adjust brightness • Press repeatedly to select different levels of display light. • Press and hold to turn on or off the bottom light. 3 sec Follow onscreen instructions to complete firmware updating. Note Update the firmware • During the firmware updating, keep the iPod/ iPhone/ iPad powered on and docked on DS1600. -
Page 12: Product Information
5 Product General information information AC/DC switching Model: AS250-050- adapter AE400 Input: 100-240 V~, 50/60 Hz, 1.2 A; Output: 5 V 4 A; Note • Product information is subject to change without prior Model: MSP- notice. C4000IC5.0 -24M-DE Input: 100-240 V~, 50/60 Hz, 0.6 A;... -
Page 13: Troubleshooting
If you encounter problems when using this device, check the following points before requesting service. If the problem remains unsolved, go to www.philips.com/support. When you contact Philips, make sure that the device is nearby and the model number and serial number are available. No power •... - Page 14 Gibson Innovations Ltd., and Gibson Innovations Ltd. is the warrantor in relation to this product. Philips and the Philips Shield Emblem are registered trademarks of Koninklijke Philips N.V. and are used under license from Koninklijke Philips N.V. DS1600_12_UM_V3.0...