Lenovo LXM-L19BH SERVICE MANUAL LXM-L19BH THESE DOCUMENTS ARE FOR REPAIR SERVICE INFORMATION ONLY.EVERY REASONABLE EFFORT HAS BEEN MADE TO ENSURE THE ACCURACY OF THIS MANUAL; WE CANNOT GUARANTEE THE ACCURACY OFTHIS INFORMATION AFTER THE DATE OF PUBLICATION AND DISCLAIMS RELIABILITY FOR CHANGES, ERRORS OR OMISSIONS.
Lenovo LXM-L19BH 1. MONITOR SPECIFICATIONS Type Color TFT LCD LCD Panel Size 48cm(19inch) Pixel Pitch 0.294mm(H) x 0.294mm(V) Video R. G. B analog interface Separate Sync H/V TTL Input H Frequency 30kHz - 80kHz V Frequency 50Hz-75Hz Display Color 16.7M Colors...
Lenovo LXM-L19BH 2. LCD MONITOR DESCRIPTION The LCD MONITOR will contain a main board, an inverter/Power board and a keypad board which house the flat panel control logic, brightness control logic and DDC. The Inverter board will drive the backlight of panel and the DC-DC conversion.
Lenovo LXM-L19BH 3. OPERATING INSTRUCTIONS 3.1 GENERAL INSTRUCTIONS Press the power button to turn the monitor on or off. The other control buttons are located by the side of the monitor. By changing these settings, the picture can be adjusted to your personal preferences.
Lenovo LXM-L19BH 3.2 ADJUSTING THE PICTURE The description for control function: Menu Menu Item Sub Menu Sub Menu Function Description Icon Icon Item Brightness & Brightness Adjust the brightness. Contrast Contrast Adjust the contrast. Adjust Horizontal Adjust the horizontal position.
Lenovo LXM-L19BH H.V Load Vload Vrms RL=120KΩ 4.4 PANEL SPECIFICATION 4.4.1 PANEL FEATURE This specification applies to the 19.0 inch Color TFT-LCD Module M190EN03 V1. The display supports the SXGA (1280(H) x 1024(V)) screen format and 16.7M colors (RGB 8-bits data). All input signals are 2 Channel LVDS interface compatible.
Page 11
Lenovo LXM-L19BH 4.4.4 Parameter guideline for CCFL Inverter Note 1: CCFL standard current is measured at 25±2℃.. Note 2: CCFL Frequency should be carefully determined to avoid interference between inverter and TFT LCD Note 3: ViCFL means Ignition Voltage for both ends of the lamp, and CCFL inverter should be able to give out a power that has a generating capacity of over 1810 voltage.
Lenovo LXM-L19BH 8.2 TROUBLE SHOOTING 8.2.1 MAIN BOARD 1.NO SCREEN APPEAR Measured CN801 pin5/6 = 12V? Check Correspondent component. Measured CN801 pin 9/10= 5V? Is there any shortage or cold solder? Measured U802 pin 2= 3.3V? Yes. There is OSD show...
Page 29
Lenovo LXM-L19BH 2. PANEL POWER CIRCUIT Check C454 should have response from 0V to 5V Measured X401 waveform is normal? When we switch the power switch from off to on Measured power supply for U401 Replace X401 Check power supply circuit...
Page 30
Lenovo LXM-L19BH 4. U4-DATA OUTPUT Measured X401 waveform is Replace X401(14.318MHz) normal? Check GM2321 (U401) Signal output. Check relative circuit to Is the waveform ok? panel Check HS/VS input signal are Check relative component normal? Replace U401 8.2.2 KEYPAD BOARD...
Page 31
Lenovo LXM-L19BH 8.2.3 POWER/INVERTER BOARD 1.) No power Check to CN102 pin12 = 12V Check Interface board Check the voltage of C905(+) Check AC line volt 120V or 220V Change F901; check BD901, Q903, and IC901 Check start voltage for the pin3 of IC901...
Page 32
Lenovo LXM-L19BH 2.) W / LED, No Backlight Check CN102 pin12 =12V Check adapter or MB Check ON/OFF signal Check Interface board Check U201 pin9=12V Change Q201 or Q202 Check the pin1 of U201 have saw tooth wave Change U201 Check D201(-) have the output of square wave at short time.
Lenovo LXM-L19BH 9 white-Balance, Luminance adjustment Approximately 30 minutes should be allowed for warm up before proceeding White-Balance adjustment. When the monitor is in ON status, press MENU button (hold on, do not release) and re-plug power cable, “Auto Level”...
Lenovo LXM-L19BH 11.BOM LIST T980KADHDLH3N Location Part No. for TPV Description Quan. Unit CBPC980KAVHW CONVERSION BOARD IDPC1942AUL1 INVERTER DC BOARD KEPC980KAZ KEY BOARD 15G8073 11 MAIN FRAME 33G4759 AI T KEY PAD 33G4760 1 L LENS 34G1387AOW B BEZEL 34G1388 IG 2B...