Fujitsu PRIMERGY RX300 S3 Service Supplement Manual page 44

Replacing the IDTemp Combo
Figure 35: Removing the connector clamp
Ê Remove the connector clamp.
Ê Insert the IDTemp Combo into the holder.
I
The routing of the SMB cable is different in the two variants for either 3.5"
HDDs or 2.5" HDDs.
Variant 3.5" hard disk drives
Figure 36: Routing the SMB cable for 3.5" HDDs
Ê Connect the SMB cable on the SAS backplane.
Ê Route the SMB Kabel as shown in the figure. Fix it under the cable clamp.
44 Service Supplement
Replacement routines
RX300 S3