Adding Detergent; Adding Fabric Softener - Samsung WA10W9 User Manual

ADDING DeTeRGeNT

1. Open the detergent drawer and then add the powder
detergent into the detergent compartment.
2. Add detergent evenly so that it doesn't brim over the edge
of the drawer.
•
•
CAUTION
If the water pressure is low, the detergent may remain in the detergent compartment.

ADDING fABRIC SOfTeNeR

1. When the proper amount (one time dose) of fabric softener is stored in the softener inlet, it is
automatically added during the last rinse cycle.
2. Do not add detergent, bleach or starch into the softener inlet.
3. Using too much softener may produce unsatisfactory results.
4. Do not open the lid during the Spin cycle. If added too early, its effectiveness will decrease.
5. Do not leave the softener in the softener dispenser for a long time as it may congeal.
If the water pressure is low, the fabric softener may remain in the softener compartment. In
this case, put the fabric softener into the tub directly.
WA10G9TEC-02961C-04_EN.indd 21
Use a reasonable amount of detergent.
If you use more detergent than the standard quantity
or the water temperature is too low and the detergent
does not dissolve in the water completely causing it
to remain on the laundry and in the hose and tub, it may cause damage such as dirtying
and discoloring the laundry.
If you use a powder detergent and it remains on the laundry, it may cause a bad odor.
Rinse the laundry sufficiently in fresh water.
If you spread a powder detergent over the laundry directly, it may result in discoloration.
Make sure to insert it into the detergent compartment.
installation & maintenance_21
2012-11-13 4:58:26