NightWatcher NW720 User Manual page 13

Operation (continued)
7
Setting the time and date
NOTE:
Time and Date must be set on the unit or it will not
record.
□
This will allow the security video taken by
Nightwatcher NW720 to display the correct date and
time it was taken.
1. Push TIME/DATE SET button for 3 seconds. The
LCD screen will flash 3 times indicating you have
entered Time/Date setting mode.
2. "YEAR" setting: "Y" and "10" are displayed on the
screen. Push the TIME/DATE SET button to set year
from "10-99". Holding this button for 3 seconds will
enable rapid scrolling through numbers. If the button
has not been pressed for 3 seconds, it will
automatically save the year and advance to allow you
to set the month.
3. Repeat this same procedure for the TIME.
4. "VIDEO/PHOTO" setting: when entering this mode,
these two icons
screen. Push the button to choose "V" (Video) or "P"
(Photo). If you have not pushed any buttons for 3
seconds, "OK" will appear on the screen, indicating it
has automatically saved the current settings. The
LCD screen will shut off automatically 10 seconds
and "V" appear on the
8
Setting the time and date
5. On the "P" (photo) setting, Nightwatcher NW720 will
take a series of digital photographs at a rate of 1-3 photos
every second when the motion sensor is triggered
①
Start
MONTH
③
Setting
⑤ HOUR
Setting
⑦ VIDEO/
PHOTO
Setting
NOTE:
In the event of a power outage please check that the
time and date have been retained
NOTE:
The NW720 comes supplied with a 3 day standby
battery for the Time and Date. (This should be
sufficient in most cases)
NB: for video/photo setting, it will resume to the default
setting, VIDEO after a power outage
13
Please contact 0845 900 6764 for further assistance.
②
YEAR
Setting
④ DATE
Setting
⑥
MINUTE
Setting
⑧
Finish
www.nightwatchersecurity.co.uk