Advertisement
Tips for ironing with professional results :-
Initially, to allow water to enter into the hose and iron, press the steam switch. This may take a few
seconds, then you will see the seam come out.
Begin to iron.
For best results, it is only necessary to press the steam switch for a few seconds at a time. It is not
necessary to activate the steam switch continuously.
There are several settings on your temperature dial. Recommended temperature settings are as
follows :-
#1, 2
– Preheat
#3
– Silk and delicate fabrics (low temperature)
#4
– Cotton and wool (medium temperature)
#5
– Linen (high temperature)
A telfon shoe is recommended to prevent garment shine and starch built-up.
When unattended or not in use, always turn off and unplug your iron.
TROUBLE SHOOTING GUIDE
PROBLEM
Iron does not heat.
No steam or very little steam.
Iron spits water.
Iron too hot.
Iron not enough hot.
PROBABLE CAUSE
No power to iron.
Temperature dial is in "OFF"
position.
Temperature dial is set on No.
1 or 2.
Little or no water in the bottle.
Bottle not high enough.
Clogged filters.
Clogged steam holes.
Iron is not hot enough.
Steam switch held down too
long.
Temperature dial is set too
high.
Temperature dial is set too
low.
SUGGESTED REMEDY
Check electric outlet.
Set temperature dial to No.3, 4
or 5.
Set temperature dial to No.3, 4
or 5.
Fill water with bottle.
Bottle must be 36" above the
ironing surface.
Remove and rinse filter under
water faucet.
Clear holes with straightened
paper clip.
Turn
temperature
(clockwise). Let iron heat up.
Release steam switch and let
iron heat up.
Turn thermostat dial down
(counter clockwise).
Turn
thermostat
(clockwise).
dial
up
dial
up
Advertisement
