Advertisement
0
1
CABINET
OPENING
(Cont.)
REAR
CROSS
CWNNE,.
IN ALTERRhTE
POSITION
STEP
STEP
2-
REMOVE
THIS
SCREW
REAR
CROSS
CHANNEL
IN ORIGIN*L
POSITION
FIG. 3
I-
L,NE
UP THE
LOWER
CROSS
CWNNEL
HOLE
WIT,,
T"E
ALTERNATE
HOLE
IN
FRAME.
FISTEN
SECURELY.
TIGHTEN
T"E
SCREW
PIT THE
OTHER
END OF
THE
CHANNEL.
/-REMOVE
THESE
SCREWS
SHWASHER
FILL LINE
FIG. 4
0
2
HOT
WATER
SUPPLY
LINE
If the fill
line comes from either right or left, it must be
installed
behind
the vertical
frame
members
which
are
2-g/16"
from the wall.
Locate fill line according
to Fig. 4.
For roughing-in
purposes,
locate 3/4"
hole 19-l/2"
from
back wall
and 6" from
left edge of cabinet.
For other
typical
fill line installations
such as water line from back,
see alternate
(dotted
line) suggestions.
All
sweat fittings
for
l/2"
O.D. copper
tubing
must be
sweat into place before attaching
to dishwasher
to prevent
excess heat on fill valve. Make certain
that there is a hand
shut off valve (A or B, Fig. 4) in the hot water supply line.
To conveniently
service dishwasher,
it is recommended
a
union be connected
in the fill line.
0
3
DRAIN
SYSTEM
The dishwasher
is equipped
with
a pump type drain.
Dishwasher
can be connected
to a drain line through
the back wall, to a sink or disposer, to either right or
left side, or to an air gap. Note Fig. 5 for dimensions
for locations
of drain line. Note Fig. 2 for area to be
kept
free of all plumbing
connections.
Connect
a
g/16"
I.D. minimum
drain line to the high loop drain
tube with
a 5/8"
O.D. x 2" long copper connector
and two clamps (furnished
by installer).
When flex-
ible hose is used, it must be resistant
to heat and
detergent
water. When copper tubing
is used, connect
it to the high loop drain tube with
a clamp.
Drain
connections
must be in compliance
with
local codes.
Do not install
check valve in drain
line. When con-
necting dishwasher
drain to a food waste disposer, be
sure to remove the knockout
(or threaded)
plug in
the disposer to ensure proper drainage.
NOTE:
Drain
Hose #B-242167
may be used
to connect
dishwasher
with disposer unit, or
to sink
drain
using Tee P-83095
or elbow
M-66093
(available as accessories).
CAUTION:
Make sure drain
hose does
not
touch
the blower
housing
or any electrical
components
or terminals.
Drain
hose must
withstand
hot water
and
detergent
and can be obtained
from a plumb-
ing hardware
or automotive
supply
outlet.
-3-
Advertisement
