Technical Data; Installation - Electrolux EUC19001W User Manual

10 electrolux
Problem
Green indicator flashing
CLOSING THE DOOR
1. Clean the door gaskets.
2. If necessary, adjust the door. Refer to

"Installation".

TECHNICAL DATA

Dimension
Rising Time
Voltage
Frequency
The technical information are situated in the
rating plate on the internal left side of the
appliance and in the energy label.
INSTALLATION
Read the "Safety Information" carefully
for your safety and correct operation of
the appliance before installing the
appliance.
POSITIONING
This appliance can be installed in a dry, well
ventilated indoor (garage or cellar) also, but
for optimum performance install this appli-
ance at a location where the ambient tem-
perature corresponds to the climate class
indicated on the rating plate of the appli-
ance:
Climate Ambient temperature
class
SN +10°C to + 32°C
N +16°C to + 32°C
ST +16°C to + 38°C
T +16°C to + 43°C
Downloaded from Fridge-Manual.com Manuals
Possible cause
There is no voltage in the mains
socket (try to connect another
appliance into it)
The appliance is not switched
on
Temperature Regulator is not on
Temperature sensor problem
Height
Width
Depth
Call an electrician
Switch on the appliance
Check the Temperature Regulator
Call the service personnel
3. If necessary, replace the defective door
gaskets. Contact the Service Center.
EUC19001W
1250 mm
545 mm
640 mm
18 h
230 V
50 Hz
REAR SPACERS
In the bag with the documentation, there
are two spacers which must be fitted as
shown in the figure.
Solution
EUC19002W
1250 mm
545 mm
640 mm
18 h
230 V
50 Hz