Advertisement
GIRA
LED-Clock/Alarm Clock/Thermometer 230 V~
Info
Instructions for Installation
Setting the Alarm Time
Alarm Time 1:
1. Wait or change (see: Display Alternation On/Off) to the time display.
2. Press the button
3. Hold the button
hold the button H or M down.
4. After setting the alarm time, release the button
Alarm Time 2:
The adjustment of the alarm time 2 takes place as with the setting of alarm time 1. The button
must only be pressed long enough that the symbol for alarm time 2 blinks.
Switch Alarm On/Off
Alarm Time 1:
1. Wait or change (see: Display Alternation On/Off) to the time display.
2. Press the button
3. Release the button
4. The alarm time 1 is switched on when the symbol lights up.
Alarm time 2:
The alarm time 2 is switched on/off as with alarm time 1. The button
enough that the symbol for alarm time 2 blinks. Then, release the button and press briefly again.
Switch Alarm Sound Off
Press the button
briefly to switch the alarm sound off.
Temperature Adjustment
The thermometer is calibrated before delivery in a climatic chamber. The temperature at the
installation site can differ from the living space temperature, due to structural conditions (outer wall,...).
Therefore, you can adjust the temperature display to the living space temperature.
1. Take a second thermometer and place it in the center of the room.
2. Wait a while and compare the two temperatures.
3. If the two measured temperatures differ greatly from one another, you can now change the
temperature display.
4. Wait or change (see: Display Alternation On/Off) to the temperature display.
5. Press the button H to lower the temperature display, or the button M to raise it. With each press of
the button H or M, the temperature display is lowered or raised by 0.5°C. This is signaled by a brief
sound. Since the temperature is displayed without decimal figures, the display only changes with
every second press of the button.
Note: In order to restore the thermometer to the delivery condition, wait or change (see: Display
Alternation On/Off) to the temperature display. Press the button (H or M) in the opposite
direction. This means that if you have raised the temperature display (button M), repeatedly
press the button H until you hear a longer sound.
LED-Clock/Alarm Clock/Thermometer 230 V~
until the symbol for alarm time 1 blinks.
down and set the alarm time with the buttons H and M. To advance quickly,
until the symbol for alarm time 1 blinks.
and then briefly press the button
03/99
.
again to switch the alarm on or off.
must only be pressed long
Page 3 of 4
Advertisement
