Advertisement
GIRA
LED-Clock/Alarm Clock/Thermometer 230 V~
Info
Instructions for Installation
Battery Change
The end of the battery charge is shown by a point (see illustration
1. To change the battery, remove the cover and open the battery drawer (see illustration
2. Replace the old battery with a new one of the same type (lithium button cell CR1025) while paying
attention to the correct polarity.
The battery is laid in the drawer with the + pole up (see illustration
3. Close the drawer and place the cover on the support ring again.
4. Do not dispose of batteries in normal household waste. Give the batteries to a suitable collection
point.
LED Display
BAT.
6
H
1
2
Illustration
Display Alternation On/Off
You can choose from alternating, time, or temperature display.
Press briefly on the button
Example: The LED Clock/Alarm Clock/Thermometer constantly alternates between time and
temperature. You want only the time to be displayed. Wait until the time appears in the
LED display and then press 1 x briefly on the button
displayed.
Press 1 x briefly on the button
and time again.
Setting the time
1. Wait or change (see: Display Alternation On/Off) to the time display.
2. Press the button H to set the hours and the button M for the minutes. To advance quickly, hold
button H or M down.
LED-Clock/Alarm Clock/Thermometer 230 V~
5
1. Button:
2. Button:
4
3. Button:
4. Display:
5. Display:
6. Display:
M
3
1 x to pause the display or to start the alternating display.
Alternating
Display
00:00
Button
press 1 x briefly
00:00
Time
Display
and the LED display alternates between temperature
03/99
) in the LED display.
).
hours/temperature correction ↓
brightness display/switch off alarm
signal/display change on/off
minutes/temperature correction ↑
alarm time 1 on/off
alarm time 2 on/off
battery end
°C
Button
press 1 x briefly
°C
Temperature-
Display
. The time will now be constantly
).
Page 2 of 4
Advertisement
