Relocate The Pedals To Y Axis; Clear The Pedal Relocation; Connection / Plug And Play; Sensitivity Adjustment - Logic3 PSU448 Instruction Manual

Calibrate the Topdrive as described in the calibration section of the game controller window. The USB driver
will only have to be installed once, after this has been done whenever you connect the Topdrive to your USB
port the "USB Steering Wheel" will appear within the "Gaming Options" window. To ensure the Topdrive
works correctly please re-calibrate the Topdrive before use.
When you have finished testing, quit by clicking on OK in the Test window, and OK in the General window.
Finally, close the Control Panel window. Now its time to load your favorite game and start playing! Note the
actual controls for the fire buttons, throttle and brake pedals are set within each individual game. Check your
game documentation for further details.

Relocate the pedals to Y Axis

1. Press the PROG button till the green LED illuminates.
2. Press the LEFT button on the D-Pad
3. Pressing a pedal now should move the Y-Axis
4. The relocation is now complete

Clear the pedal relocation

1. Press the PROG button till the green LED illuminates
2. Press the L-Wing / R-Wing or Pedals Twice.
3. The relocation is now cleared.
PS2

CONNECTION / PLUG AND PLAY

NOTE: Please ensure that your console is turned OFF before connecting or disconnecting the TOPDRIVE.
1. Connect the accelerator/brake pedal unit into the socket at the rear of the TOPDRIVE Wheel.
2. Plug the correct console plug into port 1 of your console .
3. Place the accelerator/brake pedal unit in convenient location under a table or in front of a chair within easy
reach.
4. Turn "ON" your game console and load your driving game software. You are now ready to play
The Mode Switch is designed for use only when the TOPDRIVE Wheel is being in conjunction with
PlayStation consoles only. Simply press the Mode Switch to select Digital (LED is OFF) or Analog (LED is
ON)

Sensitivity Adjustment

Sensitivity Adjustment Control:
1. The Topdrive wheel has three settings of steering sensitivity to suit your driving games – High, Middle &
Low.
2. To change between these three levels of sensitivity,
3. Press and Hold the Select and Start buttons for 3 seconds, a green LED will switch ON;