then shows the clock.
RESETTING THE STEREO
If your stereo locks up or does not work properly, use something pointed,
such as a straightened paper clip, to press RESET for about 1 second.
TURNING THE STEREO'S BEEP ON AND OFF
The stereo normally beeps when you press most buttons.
stereo's beep on or off, eject a CD if loaded.
for about 3 seconds until the
display turns off then on again.
RADIO OPERATION
PLAYING THE RADIO
1.
Press ON/OFF to turn on the stereo.
to the last station and bank selected.
2.
Press BAND to select the desired band.
when the AM band is selected.
when an FM band is selected.
3.
Tune to the desired station one of the following ways.
Manual Tuning:
Repeatedly press TUNE/SEEK TRACK - or + to tune down or up the
selected band.
Seek Tuning:
Press and hold down TUNE/SEEK TRACK - or + for about 1 second to
tune to the next lower or higher station.
Note:
If DX appears on the display, the stereo stops on both strong and weak
FM stations.
LO/DX so DX disappears.
4.
Press AUDIO CONTROL + or - to increase or decrease the volume as
desired.
To limit seek tuning to only strong FM stations, press
Then press and hold down CD
The radio automatically tunes
AM appears on the display
FMI or FMII appears on the display
To turn the