Using Relay Play - Optimus SCT-56 Owner's Manual

Using Relay Play

You can load two cassette tapes to play one after the other.
Notes:
• The cassettes you load should have the same Dolby NR type.
• You can start relay play from either Deck 1 or Deck 2.
• You can replace the tape in the idle deck during relay play.
• When a tape automatically begins playing during relay play, it
always starts from the forward ( ) playback side. Be sure to set
the tapes properly before starting relay play.
• If the deck encounters an unrecorded portion of tape more than
15 seconds long, it fast forwards the tape until it finds another
recorded portion, and resumes playback from that point (i.e.,
blank skip is automatically set).
1. Load a cassette tape in each tape compartment, then close the
compartment doors.
2. Set for the noise-reduction system you want to use. See
DOLBY NR
"Dolby Noise Reduction" on Page 7.
3. Set to
REV MODE RELAY/SKIP
4. Press or on Deck 1 or 2. Playback starts. See "Playback
Sequence."
5. Adjust the volume, tone, and balance control on your receiver/
amplifier for the desired sound.
6. To stop relay play before it automatically stops, press
the deck that is playing any time during playback.
Playback Sequence
The cassette deck repeats the following sequence 8 times (up to 32
sides).
Where playback starts in the sequence depends on which play button
you press first:
I. Side facing out, Deck 1
II. Side facing in, Deck 1
III. Side facing out, Deck 2
IV. Side facing in, Deck 2
• When you press
• When you press
• When you press
• When you press
Special Features
.
on Deck 1, playback starts at I.
on Deck 1, playback starts at II.
on Deck 2, playback starts at III.
on Deck 2, playback starts at IV.
( ) on
STOP
9