Table of Contents
Advertisement
14-678.fm Page 10 Wednesday, June 2, 1999 9:29 AM
Environment
Avoid using the deck in the following conditions:
• In areas with high temperatures (near a heater,
exposed to direct sunlight, for example.)
• In areas with extremely low temperatures.
• In areas where there is excessive humidity.
• In a dusty atmosphere.
• In areas where power line voltage fluctuations are
severe (in which case the use of a voltage regulator
may be advisable).
Cleaning the Tape-Handling Parts
Dirt, dust or particles of the tape's coating can accumu-
late on the tape heads and other parts that the tape
touches. This can greatly reduce the performance of the
cassette player. After every 20 hours of tape player oper-
ation, follow these steps to clean the tape-handling parts
or use a cassette deck cleaning kit (available at your lo-
cal RadioShack store).
1. Remove the batteries and disconnect any other
power source.
2. Open the cassette compartment door and press
to expose the tape-handling parts.
PLAY
3. Use a cotton swab dipped in denatured alcohol or
tape head cleaning solution to clean the tape guides,
record/play head, erase head, pinch roller, and cap-
stan.
4. When you finish cleaning, press
close the cassette compartment door. Then recon-
nect power.
10
TROUBLESHOOTING
If the cassette deck is not working as it should, the follow-
ing suggestions might help. If you follow the suggestions
in this chart and the cassette deck still does not work
properly, contact your local RadioShack store for assis-
tance.
Problem
No sound while
the tape is
operating.
Strange
tone quality
or
ragged sound.
cannot be
REC
operated.
Low volume or
weak sound
with mute inter-
vals.
Poor operation
of skip function.
and
STOP/EJECT
Probable Cause
Suggestion
Volume of stereo
Adjust the vol-
receiver/amplifier
ume.
is set to "0."
Input function
Set the input
switch of ampli-
function switch to
fier is not set to
.
TAPE
.
TAPE
Noise reduction
Set the noise
switch is not in
reduction switch
the correct posi-
to match the
tion.
appropriate kind
of recorded tape
you are using.
Erase-protection
Cover the erase-
tabs are removed.
prevention tab
slots with adhe-
sive tape.
Tape heads are
Clean the tape
dirty.
heads.
Mute recorded
Increase the mute
length between
length so that it is
two successive
longer than 4 sec-
music selections
onds or use a
is not longer than
tape that has a
4 seconds.
mute length which
is longer than 4
seconds.
- Quick Links:
- Controls and Functions
Hide quick links:
Advertisement
Table of Contents
