Toro 30856 Operator's Manual page 33

Figure 26
1. Top fitting on king pin
• Tie rod ball joints (2) (Figure 26)
• King pin bushings (2) (Figure 26). The top fitting
on the king pin should only be lubricated
annually (2 pumps).
• Lift arm bushings (1 per deck) (Figure 27)
Figure 27
• Lift cylinder bushings (2 per deck) (Figure 27)
• Cutting unit spindle shaft bearings (1 per cutting
unit) (Figure 28)
• Cutting unit carrier arm bushings (1 per cutting unit)
(Figure 28)
• Rear roller bearings (2 per cutting unit) (Figure 29
or Figure 30 )
Important: Make sure the grease groove in
each roller mount aligns with the grease hole in
each end of the roller shaft. To help align the
groove and hole, there is also an alignment mark
on one end of the roller shaft.
Note: On rollers equipped with flush grease
fittings (Figure 30) a grease gun nozzle adapter is
required. Order Toro Part No. 107-1998 from your
Authorized Toro Distributor.
33
Figure 28
Figure 29
Figure 30