Toro 71199 Operator's Manual page 31

5. Install the mower pivot mount brackets to the front axle
with bolts and locknuts (Fig. 39).
1
Figure 39
1. Pivot mount brackets
6. Move the height-of-cut lever into the "A" notch.
7. Slide the end of the long rod through the hole in the
mower mount (Fig. 40). Install the washer and hairpin
cotter to secure the rod in place. Repeat this step on the
opposite side of the mower.
1
4
2
m–1805
Figure 40
1. Rod
2. Hairpin cotter and washer
1
m–1888
2
3
3. Leveling bracket
4. Mower mount
31
8. Mount the slotted mower leveling bracket onto the pin
on the height-of-cut arm (Fig. 40). Install the washer
and hairpin cotter to secure the mower. Repeat this step
on the opposite side of the mower.
9. Install the blade control rod onto the blade control arm
and secure it with the washer and hairpin cotter
(Fig. 41).
1
2
Figure 41
1. Hairpin cotter and washer
10. Move the height-of-cut lever into the "D" notch to
make it easier to install the height-of-cut lift assist
spring.
11. Hook the height-of-cut lift assist spring onto the
retaining bolt (Fig. 42), using the spring tool provided
with the machine.
1
3
Figure 42
1. Spring
2. Bolt
12. Check the side-to-side blade level; refer to Side-to-Side
Mower Leveling, page 32.
m–1897
2. Rod
2
m–1851
3. Spring tool