Cleaning; Cleaning Under The Mower; Waste Disposal - Toro Z Master G3 Operator's Manual

Note: Make sure the L end of the spring is installed
behind the deck edge before installing the bolt as
shown in Figure 97.
3. Install the bolt and nut. Place the J hook end of the
spring around the grass deflector (Figure 97).
Important: The grass deflector must be able to
lower down into position. Lift the deflector up
to test that it lowers into the full down position.
Figure 97
1. Bolt
2. Spacer
3. Locknut
4. Spring
5. Spring installed
6. Grass Deflector
7. L end of spring, place
behind deck edge before
installing bolt
8. J hook end of spring

Cleaning

Cleaning Under the Mower

Service Interval: Before each use or daily
1. Disengage the blade control switch (PTO), move the
motion control levers to the neutral locked position
and set the parking brake.
2. Stop the engine, remove the key, and wait for all
moving parts to stop before leaving the operating
position.
3. Raise the mower to the transport position.

Waste Disposal

Engine oil, batteries, hydraulic oil, and engine coolant
are pollutants to the environment. Dispose of these
according to your state and local regulations.
60