Table of Contents
Advertisement
lack of awareness of the effect of ground
conditions, especially slopes;
incorrect hitching and load distribution.
Preparation
While mowing, always wear substantial footwear and
long trousers. Do not operate the equipment when
barefoot or wearing open sandals.
Thoroughly inspect the area where the equipment is to
be used and remove all objects which may be thrown
by the machine.
Warning—Fuel is highly flammable.
– Store fuel in containers specifically designed for
this purpose.
– Refuel outdoors only and do not smoke while
refuelling.
– Add fuel before starting the engine. Never remove
the cap of the fuel tank or add fuel while the
engine is running or when the engine is hot.
– If fuel is spilled, do not attempt to start the engine
but move the machine away from the area of
spillage and avoid creating any source of ignition
until fuel vapors have dissipated.
– Replace all fuel tanks and container caps securely.
Replace faulty silencers.
Before using, always visually inspect to see that the
blades, blade bolts and cutter assembly are not worn or
damaged. Replace worn or damaged blades and bolts
in sets to preserve balance.
On multi-bladed machines, take care as rotating one
blade can cause other blades to rotate.
Operation
Be alert, slow down and use caution when making
turns. Look behind and to the side before changing
directions.
Do not operate the engine in a confined space where
dangerous carbon monoxide fumes can collect.
Mow only in daylight or in good artificial light.
Before attempting to start the engine, disengage all
blade attachment clutches and shift into neutral.
Use care when pulling loads or using heavy
equipment.
– Use only approved drawbar hitch points.
– Limit loads to those you can safely control.
– Do not turn sharply. Use care when reversing.
Watch out for traffic when crossing or near roadways.
Stop the blades rotating before crossing surfaces other
than grass.
When using any attachments, never direct discharge of
material toward bystanders nor allow anyone near the
machine while in operation.
Never operate the machine with damaged guards or
without safety protective devices in place.
Do not change the engine governor settings or
overspeed the engine. Operating the engine at
excessive speed can increase the hazard of personal
injury.
Before leaving the operator's position:
– disengage the power take-off and lower the
attachments;
– change into neutral and set the parking brake;
– stop the engine and remove the key.
Disengage drive to attachments, stop the engine, and
disconnect the spark plug wire(s) or remove the
ignition key
– before clearing blockages or unclogging chute;
– before checking, cleaning or working on the
lawnmower;
– after striking a foreign object. Inspect the
lawnmower for damage and make repairs before
restarting and operating the equipment;
– if the machine starts to vibrate abnormally (check
immediately).
Disengage drive to attachments when transporting or
not in use.
Stop the engine and disengage drive to attachment
– before refuelling;
– before removing the grass catcher;
– before making height adjustment unless adjustment
can be made from the operator's position.
Reduce the throttle setting during engine run-out and,
if the engine is provided with a shut-off valve, turn the
fuel off at the conclusion of mowing.
Keep hands, feet, hair and loose clothing away from
attachment discharge area, underside of mower and
any moving parts while engine is running.
Use only Toro-approved attachments. Warranty may
be voided if used with unapproved attachments.
4
Advertisement
Table of Contents
