Table of Contents
Advertisement
2. Place the left side baffle and the right side baffle inside
the cutting chamber so the extended lugs are
interlocked. Secure them with 4 locknuts (5/16 inch)
and 4 lock washers (Fig. 12).
2
5
m–3813
5
Figure 12
1. Baffle left side
2. Baffle right side
3. Bolt, 5/16 x 1-1/4 inch
3. Tighten all mounting hardware securely.
4. Rotate the blades to ensure that there is at least
1/8 inch (3 mm) clearance between the blades and
baffles.
5. Using existing hardware, make sure all holes in deck
are plugged with a nut and bolt.
Warning
Open holes in the mower expose you and others to
thrown debris which could cause injury.
Never operate mower without hardware
mounted in all holes in mower.
Install hardware in mounting holes when
mulching baffle is removed.
3
3
1
5
4
4
5
4. Lock washer
5. Locknut, 5/16 inch
Installing and Removing Kickers
The following instructions are for removing and installing
kickers. The kickers are used for mulching only. The
following procedures are written as though you were to
install the kickers. Reverse the procedures to remove
them.
Important
The kickers are used only for mulching.
The kickers must be removed when in side discharge
mode.
1. Place the kicker plate into position (Fig. 13).
1
3
2
Figure 13
1. Kicker plate
2. Kicker
2. Secure the kicker plate with a bolt (5/16 x 1 inch), flat
washer, and locknut.
3. Position the kickers (Fig. 13) and secure them with
3 bolts (5/16 x 1 inch), spacers, flat washers, and
locknuts (Fig. 14).
2
3
4
Figure 14
1. Kicker
2. Bolt, 5/16 x 1 inch
3. Spacer
4. Tighten all mounting hardware securely.
20
4
2
3. Right/center joint
4. Center line
1
5
m–4033
4. Flat washer
5. Locknut, 5/16 inch
Advertisement
Table of Contents
