Toro 73542 Operator's Manual page 33

10. Remove the spark plugs and check their condition;
refer to Changing Spark Plugs, page 22.
11. With the spark plugs removed from the engine, pour
two tablespoons of engine oil into the spark plug hole.
12. Use the electric starter to crank the engine and
distribute the oil inside the cylinder.
13. Install the spark plugs and tighten to recommended
torque; refer to Changing Spark Plugs, page 22.
Note: Do not install the wire on the spark plug(s).
14. Remove the battery from the chassis, check the
electrolyte level, and charge it fully; refer to Servicing
the Battery, page 30.
Note: Do not connect the battery cables to the battery
posts during storage.
Important
The battery must be fully charged to
prevent it from freezing and being damaged at
temperatures below 32 F (0 C). A fully charged battery
maintains its charge for about 50 days at temperatures
lower than 40 F (4 C). If the temperatures will be above
40 F (4 C), check the water level in the battery and
charge it every 30 days.
15. Check and tighten all bolts, nuts, and screws. Repair or
replace any part that is damaged.
16. Paint all scratched or bare metal surfaces.
Paint is available from your Authorized Service
Dealer.
17. Store the machine in a clean, dry garage or storage
area.
18. Remove both the ignition and KeyChoice keys and put
them in a safe place place out of the reach of children.
19. Cover the machine to protect it and keep it clean.
33