Installing The Auxiliary Handle; Installing The Guard - Toro 51486 Operator's Manual

2

Installing the Auxiliary Handle

Parts needed for this procedure:
1. Position the auxiliary handle on the shaft of the trimmer with the
smooth surface facing the operator (Figure 2).
1. Auxiliary handle
2. Latch
2. Slide the brace into the auxiliary handle so that the brace rests in
the groove along the shaft (Figure 2).
3. Slide the latch from the left through the handle and brace as
shown and tighten the latch screw with a Phillips head screwdriver
(Figure 2).
G017277
Figure 2
3. Brace
3

Installing the Guard

Parts needed for this procedure:
1. Slide the guard onto the trimmer base as shown in Figure 3.
1. Phillips head screw
2. Secure the guard using a Phillips head screw.
4
G017622
Figure 3
2. Guard