Table of Contents
Advertisement
Setup
Installing the Handle
Folding or unfolding the handle improperly can
damage the cables, causing an unsafe operating
condition.
S
Do not damage the cables when folding or
unfolding the handle.
S
If a cable is damaged, contact an Authorized
Service Dealer.
1. Slip the cable
anchor onto the left
lower handle end.
Note: Ensure
that the notch
on the handle
end (A) faces
up.
2. Install the left
lower handle end
and cable anchor
onto the pin on the
left handle bracket.
Note: Use the
upper hole in
the handle.
3. While holding the left lower handle end in
position, slip the cable guide onto the right lower
handle end, push the handle end and cable guide
inward, and install it onto the pin on the right handle
bracket.
4. Insert the
cable into the
cable anchor on
the left handle
bracket.
5
5. Attach the
upper handle onto
the lower handle.
Note: Ensure
that the handle
knobs are on
the inside of the
handle.
6. Tighten the handle
knobs as tight as you
can.
A
m–8050
m–8052
m-8054
m–8051
3352-982
m-8055
m-6289
Advertisement
Table of Contents
