Optimus CD-8400 Owner's Manual page 15

Programming a Sequence While a CD is Playing
While the CD changer is playing, you can program a sequence of tracks, but not
an entire CD. Press
PGM
remote control's number buttons and
When the current track finishes playing or you press , programmed play starts.
Or, you can store the track currently being played directly into memory. While
the track is playing, press
again to store the current track. You might find this feature convenient to
PGM
use along with hi-lite scan.
Erasing a Programmed Selection
In the program mode (when
the last-stored selection (track or CD). The new last-stored selection appears on
the display until you press
Note: You cannot erase a selection that is currently playing or that has already
played.
Clearing a Programmed Sequence
Turning off the CD changer does not clear the programmed sequence. To clear
the sequence, do any of the following:
• Press when the CD is stopped.
• Start best selection play.
• Select ,
ALL SINGLE
gle play slot while programming a sequence.
• Press while programming a sequence.
RANDOM
Storing a Pause within a Programmed Sequence for
Recording to Cassette
When you record a programmed sequence onto a cassette tape, you can pro-
gram a pause to occur after the last selection you plan to record on the first side
of the tape (so you can turn the tape over).
To store a pause, press
Sequence" on Page 14.
PA
During play, when the CD changer pauses and displays
and press to resume recording.
Notes:
• You cannot program a pause as the first or last selection.
• You cannot program two pauses in a row.
Special Features
during play, then select the CD and track using the
DISC SET/TRACK SET
once to enter the program mode, then press
PGM
PGM appears on the display), press
/ (or on the remote control).
, , previous scan, or play the CD in the sin-
CUSTOM
on the remote in Step 3 of "Programming a
appears on the display.
, and press .
PGM
to erase
CLEAR
, turn over the tape
/
15