Mechanical Instructions - Philips TE2.1E AA Service Manual

TE2.1E AA
4. Mechanical Intructions
Disassembly procedure is explained as below. Before disassembling the TV set please
read the safety instructions and warning parts of the service manual.
• Turn off TV and plug the mains out
• Remove screws (10 pieces) to dismount the back cover
• Disconnect the following sockets to take the chassis out ;
Deflection cables
Degaussing coil
Speaker cable
Power cable
• Remove the ground cable localised between tube module and mass wire.
• Remove the CRT drive module from picture tube.
• Remove anode cable localised on the picture tube.
• Slide out the chassis through the guides (no screws, straps or other fixing).
Please follow the assembly instructions explained below;
• Before inserting the chassis into guides, check the control buttons in front of the
chassis. In case of misplacement of control buttons place them into correct position.
• Slide the chassis into guides until the connection cables could be reached to their
sockets.
• Plug in the power cable socket to KP03.
• Plug in the degauss cable socket to KP02.
• Plug in the speaker cable socket to KA04.
• Place the CRT drive module on picture tube.
• Slide the chassis completely on its place. Be careful about control buttons.
• Plug in the deflection cable socket to KD02 and KD01.
• Place the anode cable to picture tube. Be careful about high voltage!
CRT drive module must be grounded via mass cable.
• Place the back cover back to its place.(10 screws)
• Plug the mains in.
• Turn on the TV.
EN 6