Table of Contents
Advertisement
Air Filter
Maintenance Interval
The air filter should be cleaned daily, or more
often when working in extremely dusty
conditions.
Replace after every 100 hours of operation.
Air Filter Cleaning
1.
Unsnap the air filter cover (Fig. 9).
2.
Remove the foam filter (Fig. 9).
3.
Clean the filter with warm, soapy water. Let the
filter completely dry.
4.
Apply a light coat of SAE 30 motor oil to the
foam filter and squeeze out all excess oil.
5.
Reassemble the filter and filter cover (Fig. 9).
Fuel Filter
Maintenance Interval
The fuel filter should be replaced after every 100
hours of operation.
Fuel Filter Replacement
The fuel filter is attached to the end of the fuel
pick-up hose inside the fuel tank (Fig. 10).
To replace the fuel filter:
1.
Make sure the fuel tank is empty.
2.
Remove the fuel cap.
3.
Using a wire hook, gently pull the fuel filter out
through the fuel filler opening (Fig. 10).
4.
Grasp the fuel hose next to the fuel filter fitting
and remove the filter, but do not release the hose.
10
5.
While still holding on to the fuel hose, attach the
new fuel filter.
6.
Drop the new fuel filter back into the fuel tank.
7.
Make sure that the fuel filter is not stuck in a
corner of the tank, and that the fuel hose is not
doubled over (kinked) before refueling.
Spark Plug
Maintenance Interval
The spark plug should be removed from the
engine and checked after each 25 hours of
operation.
Replace the spark plug after every 100 hours of
operation.
Spark Plug Maintenance
1.
With the engine at ambient (room) temperature,
remove the socket head screw holding the
muffler cover, then remove the muffler cover
(Fig. 11).
2.
Loosen the cylinder cover screw and lift off the
cylinder cover (Fig. 12).
3.
Twist the high tension lead boot on the spark
plug back and forth a couple of times to loosen
the boot, then pull the boot off of the spark plug.
4.
Remove the spark plug.
5.
Clean the electrodes with a stiff brush (Fig. 13).
6.
Adjust the electrode air gap to .024–.028 in.
(0.6–0.7mm) (Fig. 13).
7.
Replace the spark plug if it is oil-fouled,
damaged, or if the electrodes are worn down.
8.
Do not overtighten the spark plug when
installing. The tightening torque is 95–148 in.
lbs. (10.7–16.6 N m).
9.
Reinstall the cylinder and muffler covers (Figs.
11 and 12).
Advertisement
Table of Contents
