Onkyo TX-SR573 Instruction Manual page 52

Advanced Setup
Speaker Distance
To get the best from surround sound, it's important that
the sound from each speaker reaches the listener at the
same time. To achieve this, you need to specify the dis-
tance from each speaker to the listening position.
1
Measure and make a note of the
distance from each speaker to
the listening position.
2 Press the [RECEIVER] REMOTE
RECEIVER MODE button, followed by the
[SETUP] button.
3
Use the Up and Down [
buttons to select "2. Sp Dis-
tance," and then press the
ENTER
[ENTER] button.
ENTER
4
While "Unit" is displayed, use the
Left and Right [
select "feet" or "meters".
ENTER
meters: Distances can be set in
5
Use the Down [
select a speaker, and use the Left
and Right [
ENTER
specify the distance.
6
Repeat step 5 for all speakers.
Note:
Speakers that you set to No or None in
the Speaker Configuration (page 32)
cannot be selected.
7 Press the [SETUP] button.
Setup closes.
52
]/[ ] buttons to
feet: Distances can be set in feet.
Range: 1 to 30 feet in 1-foot
steps.
meters. Range: 0.3 to 9
meters in 0.3-meter steps.
] button to
]/[ ] buttons to
Notes:
• The Center and Subwoofer distances can be set up to
5 ft. (1.5 m) more or less than the Front distance. For
example, if the Front distance is set to 20 ft. (6 m), the
Center and Subwoofer distances can be set between 15
and 25 ft. (4.5 and 7.5 m).
• The Surround and Surround Back distances can be set
up to 5 ft. (1.5 m) more or 15 ft. (4.5 m) less than the
Front distance. For example, if the Front distance is set
to 20 ft. (6 m), the SurrRight, Surr Left, Surr Back R,
and Surr Back L distances can be set between 5 and 25
ft. (1.5 and 7.5 m).
Speaker Levels
You can set the volume level of each speaker so that all
speakers can be heard equally at the listening position.
]/[ ]
Speaker levels cannot be adjusted while the
AV receiver is muted.
1
RECEIVER
2
ENTER
ENTER
3
Press the [RECEIVER] REMOTE
MODE button, followed by the
[SETUP] button.
Use the Up and Down [
buttons to select "3. Level Cal,"
and then press the [ENTER] but-
ton.
A pink noise test tone is output by the
front left speaker.
Turn up the volume so that you
can hear the test tone suffi-
ciently.
As each speaker outputs the test tone,
its name appears on the display.
]/[ ]