Onkyo TX-SR573 Instruction Manual page 33

First Time Setup
6
Use the Down [
select "Surround," and then use
ENTER
the Left and Right [
tons to select
.
Small: Select if the surround speak-
Large: Select if the surround speak-
ENTER
None: Select if no surround speakers
Note:
• If the Front setting in step 4 is set to
Small, the Large option cannot be
selected.
7
Use the Down [
select "Surr Back," and use the
ENTER
Left and Right [
select
Small: Select if the surround back
Large: Select if the surround back
ENTER
None: Select if no surround back
Notes:
• If the Surround setting in step 6 is set
to None, this setting does not appear.
• If the Surround setting in step 6 is set
to Small, the Large option cannot be
selected.
8
Use the Down [
select "Surr Back Ch," and use
ENTER
the Left and Right [
tons to select
2ch: Select if two (left and right)
1ch: Select if one surround back
ENTER
Note:
• If the Surround and Surr Back set-
tings in steps 6 and 7 are set to None,
this setting does not appear.
9
Press the [SETUP] button.
Speaker configuration is complete.
] button to
]/[ ] but-
, , or
ers are small.
ers are large.
are connected.
] button to
]/[ ] buttons to
, , or
speakers are small.
speakers are large.
speakers are connected.
] button to
]/[ ] but-
or .
surround back speakers are
connected.
speaker is connected.
Testing the Speakers
To make sure that all of the speakers are working
properly, press the remote controller's [TEST
TONE] button. A test tone will be output by each
speaker in turn and the name of each speaker will
appear on the display. To turn off the test tone, press
the [TEST TONE] button again.
• If the test tone is not produced by a speaker, or it's
produced by a speaker other than the one shown
on the display, you may have wired it incorrectly
and should check your connections (see page 17).
• If the test tone is not produced by a speaker, and
its name does not appear on the display, check the
speaker configuration (see page 32).
.
33