Removing The Blade; Sharpening The Blade; Inspecting The Blade; Balancing The Blade - Toro 22177TE Operator's Manual

3. Drain the gasoline from the fuel tank; refer
to Emptying the Fuel Tank and Cleaning the
Fuel Filter.
4. Tip the lawn mower onto its right side
(Figure 33).
Figure 33
1. Blade
2. Blade nuts

Inspecting the Blade

Carefully examine the blade for sharpness and
wear, especially where the flat and the curved parts
meet (Figure 34A). Because sand and abrasive
material can wear away the metal that connects the
flat and curved parts of the blade, check the blade
before using the lawn mower. If you notice a slot
or wear (Figure 34B and Figure 34C), replace the
blade; refer to Removing the Blade.
Figure 34
1. Sail
2. Flat part of the blade
Note: For the best performance, install a new
blade before the cutting season begins. During
the year, file down any small nicks to maintain the
cutting edge.
3. Accelerator
4. Anti-scalp cup
3. Wear
4. Slot formed
A worn or damaged blade can break, and a
piece of the blade could be thrown into the
operator's or bystander's area, resulting in
serious personal injury or death.
• Inspect the blade periodically for wear
or damage.
• Replace a worn or damaged blade.

Removing the Blade

Grasp the end of the blade using a rag or a
thickly padded glove. Remove the blade nuts,
the anti-scalp cup, the accelerator, and the blade
(Figure 33).

Sharpening the Blade

File the top side of the blade to maintain its
original cutting angle (Figure 35A) and inner
cutting edge radius (Figure 35B). The blade will
remain balanced if you remove the same amount
of material from both cutting edges.
Figure 35
1. Sharpen at this angle only. 2. Maintain the original radius

Balancing the Blade

1. Check the balance of the blade by placing
the center hole of the blade over a nail or
screwdriver shank clamped horizontally in a
vise (Figure 36).
Figure 36
27
here.