Advertisement
3. Self-cleaning
1 Fill the tank to the MAX mark (see our recommendations on the type of water to use)
2 Put the thermostat control on MAX and the steam control on DRY (
3 Place the iron on its heel and wait until the light goes out.
5 Remove the anti-calc valve
6 Shake the iron gently until all
the water (and any impurities)
AUTO
has drained from the
soleplate.
2
7 Replace the anti-calc valve.
8 When the soleplate is just
warm, wipe the iron with a soft
cloth.
4. PUTTING YOUR IRON AWAY
1 Place the cursor on DRY (
2 Unplug the iron and wait until the soleplate
has cooled.
3 Empty the tank
1
4 Wind the cord around the heel and fix
the clip onto the cord
5 Store the iron upright on its heel.
D . SAFETY PRECAUTIONS
• Be careful! Your electrical installation must correspond to that of your iron (120 V a.c.).
Connecting to the wrong voltage may cause irreparable damage to the iron and your gua-
rantee will be voided.
• This iron must be plugged into an earthed socket. If you are using an extension lead,
ensure that it is bipolar (13A) with an earth.
• If the cord is damaged, it must be replaced immediately by an Approved Service Centre as
this is dangerous.
• Never immerse the iron in water!
• The appliance must be unplugged before filling or emptying the tank
• If the iron is dropped, have it checked by a professional before reuse: invisible damage
may be dangerous.
• The soleplate of the iron may be very hot:
- never touch it
- always leave it to cool before you put it away
- never leave your iron unattended when plugged in or when the soleplate is still hot.
- keep your iron away from children.
• Never take your iron apart: consult your Approved Service Centre.
(twice a month)
1
)
2
4 Unplug the iron and place over the sink.
AUT
UTO
AUTO
1
)
1
2
2
AUTO
Advertisement
